In the process of using stainless steel filters, the troublesome problem for customers is that the filter is damaged too quickly, which in turn increases the cost of life and helps customers reduce the cost of data in the fierce competition in the business. Consider the problem Stainless steel filters have wear resistance. Nevertheless, improper use can also constitute damage too quickly.

How to prevent the stainless steel filter from being damaged too quickly? The main reasons for the too fast damage of the plastic particle mesh are clay accumulation, wrong steering of the motor, poor fit between the screen and the screen frame, and poor quality of the screen. Clay accumulation is too small to fluctuate, it is difficult to screen under the condition of polymer drilling fluid, and the viscous force of drilling cuttings (clay) cannot be effectively overcome, resulting in accumulation of drilling cuttings on the screen and rapid damage to the screen.

Solution: Increase the oscillation fluctuation, wash the screen and drill cuttings with sprayed water to reduce the viscosity of the drill cuttings. Adjust the view point of the screen at the end of the sand discharge port downward to facilitate the discharge of rock debris by gravity. For 304 filter screen manufacturers, it may cause slurry running. Adjust the mesh size of the stainless steel filter screen or adjust the flow rate of a single screen. The punching mesh filter cartridge is made. The flow stop point of the drilling fluid is close to the outlet of the screen, so that the drilling cuttings can be discharged smoothly under the smooth effect of the drilling fluid.